By providing early warning in the event of fire, smoke detectors can allow you and your family sufficient time to reach safety. Experts report that you can increase your chances of surviving in a home fire by 50% simply by having smoke detectors. Click here for more information about installing  smoke detectors in Los Angeles, my electrical company’s service area.

If your house was built before 1950, it likely has electrical wires with cloth insulation. Over time, the cloth dries out and becomes brittle. Eventually, it crumbles off the wire, exposing bare wires that can short-circuit and cause shocks or fires. Old cloth-insulated wires should be replaced with plastic-insulated wires. Plastic insulation lasts indefinitely and completely resolves the safety issue. Click here for more information about replacing cloth  wiring insulation.

The National Electrical Code requires that outlets in the vicinity of water be equipped with a device called a “Ground Fault Circuit Interrupter” or GFCI (also called GFI). GFCIs are required in all bathrooms, kitchens, garages, pools, and some outdoor areas. GFCIs can protect your family against deadly electrical shocks and are inexpensive to install. Click here for more information about GFCIs and GFIs.

Knob & Tube wiring gets its name from the white ceramic knobs around which wires were wound and the short ceramic tubes through which wires were guided. This type of wiring is usually found in homes built before 1935. In the Los Angeles and some other parts of the country, knob and tube can sometimes be seen in houses built as late as 1950. My electrical company specializes in replacing Knob and Tube wiring in the L.A. area — much of it is in Pasadena and other parts of the San Gabriel Valley.

Knob & Tube systems use old cloth-insulated wires and are not grounded. We strongly recommend that Knob & Tube wiring be replaced to eliminate fire and electrical shock hazards.

An electrical surge is a sudden increase in power that flows through electrical wires. Surges can cause damage to computers, phones, entertainment systems, microwaves, stoves, fridges, washers – any device that has electronic components such as sensors and timers. Today, that’s most appliances. A Whole House Surge Protector can save your appliances and electronic devices and save you thousands of dollars in damage.

Look for our $50 discount coupon for the installation of whole house surge protectors at www.theelectricconnection.com.

A properly grounded electrical system routes occasional leaking electricity through a “ground wire” into the ground. Without grounding, excess electricity can cause fires, damage to electrical appliances and computers, and also shocks to residents.

Older homes built under earlier electrical codes will often have outlets for two-prong plugs. This is often an indication of an ungrounded electrical system. Sometimes, the outlets have been replaced with the modern three-prong type, but without actually adding a ground wire. This can make it appear that the system is grounded when it’s not.

Even when your wiring system has a ground wire, the grounding may fail due to loose or corroded connections and splices. A qualified electrician can check your wiring with a special tester to determine if it’s fully grounded. The Electric Connection offers this testing as a free service with every electrical job that we do in the L.A. area.

There is now conclusive evidence that both Zinsco and Federal Pacific Electric (FPE) “Stab-Lok” electrical panels can fail. (Electrical panels contain your circuit breakers or fuses.) Fires and electrical shocks can result. These brands were installed in the 1950s to 1980s. The failure rates as they age are much higher than for other brands and represent a real electrical hazard. We recommend all Zinsco and FPE electrical panels and circuit breakers be replaced with modern electrical equipment. Click here for more information about Zinsco and Federal Pacific electrical panels. One of the specialties of The Electric Connection is panel upgrades. We’re possibly the most active company in Los Angeles when it comes to electrical panel replacements. We offer a free safety check of your L.A. electrical panel box with every job.

Circuit breakers and fuses protect your electrical wiring from overloads of electricity. Overloading can melt wires and cause fires and electrical shocks. Whenever a wire is overloaded, the circuit breaker or fuse is supposed to cut the flow of electricity.

Sometimes older circuit breakers don’t work fast enough and allow too much current through. Fuses can also be a safety concern. Sometimes, they’ve been replaced with improperly-sized fuses and no longer protect wires from overloading. These safety issues can be solved by installing modern circuit breakers. Click here for a coupon for a free check of your electrical circuit breaker box with your next electrical job.

Most homes have copper electrical wires. However, from the mid-1960s to the mid-1970s, over 2,000,000 U.S. homes were wired with aluminum. The U.S. Consumer Products Safety Commission has determined that aluminum wiring is hazardous as, over time, connections and splices can fail, resulting in fires and shocks.

Fortunately, a qualified electrician can upgrade an aluminum wiring system without replacing all the wires with copper. It’s possible to eliminate the fire hazard by upgrading only connection points and splices. Aluminum wiring safety retrofits should be done only by electricians specifically trained to upgrade aluminum wiring safely.

If you think it’s possible that your Los Angeles home has aluminum wiring, you can get a free checkwith your next electrical job. One of the specialties of The Electric Connection is efficient and effective safety upgrading of aluminum wiring in the Los Angeles area.

Click here to visit our website.

We all like using lights that we have collected over the years, but along with this also comes a great deal of responsibility. Please check any Christmas lights or decorations, such as wreaths, that light up for before they are used. The plastic or glass that surrounds the light should be intact, and should not contain any cracks or breaks. Please inspect the wires for tears fraying or damage.

If lights are being plugged in outside on the trees, roof top, doors, or driveway make sure you have enough electrical outlets. Do not overload your outlets and use only ground fault outlets as this will help to keep your lights and yourself safe, as they will most likely be exposed to wetness and moisture. Also make sure your extension cords do not become a tripping hazard.

When choosing a real tree, make sure it’s not too dry and not close to any candles. Christmas lights can be used to decorate real and synthetic Christmas trees. Lights should be in their best condition before being placed on the tree. Turn all Christmas lights and decorations off when you leave the house or go to bed to avoid electrical fire. Don’t use electrically powered ornaments or lights on metal decorative trees or decorations as the sharp edges may cut the cord and cause a shock and fire hazard. Due to heat danger keep your tree 3-4 feet away from fireplaces, electric heaters and floor registers.

4. Christmas “bubble” lights were popular in the 1950’s and contain coloured liquid. These should be kept away from children, as the covering of the lights can be broken, and children may attempt to drink the liquid inside. Strings of lights should be kept tucked away or taped to walls so that children cannot easily pull the cords and injure themselves or damage furniture.

5. LED’s are much more energy efficient and give off almost no heat. LED lights help protect from overloading outlets they are much safer and you can use more of them with the same available power source so your home will look like a Christmas wonderland!

Happy Halloween to all of our customers!

Programmable thermostats have become hugely popular this Fall and Winter and the reason is that they provide some very substantial energy saving benefits, improved comfort, convenience and cost – $$$ effective savings. These thermostats save energy and money on utility bills by allowing residents to set home temperatures according to various different factors.

Programmable thermostats supply personal comfort through pre-set temperature levels and are generally more convenient and accurate than manual thermostats.

Here is the best part: If you’re looking to cut back expenses, you will usually see the return on your programmable thermostat investment within one year. When used properly, this device can save residents about $150 annually. Programmable thermostats are also a plus for the environmentally conscious because they contain no mercury and are eco-friendly. Using less energy helps to reduce greenhouse gas emissions associated with energy production.

If you are a homeowner who work s outside the home during the day and have a different schedule on the weekend, a programmable thermostat can offer many benefits.

Programmable thermostats can be set to adjust the temperature of a home according to a your schedule. Here is the best part about this: the temperature on programmable thermostats can be set to change based on whether or not the home is occupied or whether residents are asleep or awake. For example, in the morning before you wake up, the thermostat can be preset for a slightly warmer temperature. As well, the thermostat can be adjusted for both heating and cooling seasons.

Programmable thermostats can automatically store settings and repeat those settings each day. However, they can still be manually set, overriding the programming when desired. A programmable thermostat generally allows more precise temperature management and a wider range of selections, offering a number of programming choices.

Most conveniently, it provides daily programming that allows one schedule to be used each day. Additionally, you can program your thermostat with different settings for the weekend. In fact, most programmable thermostats have a full seven-day programming ability, allowing for a different temperature schedule for every day of the week.

Call Expert Electric and we will be happy to install a programmable thermostat for you!

For you to be able to ensure that you get the best possible job done in your home, you should limit your options among contractors that will be able to take the best possible care of your home systems. Even if highly skilled professionals tend to ask for higher fees than their other counterparts, there is no doubt that spending your money on their services will be worth it. Here are some points that you should keep in mind as you go about looking for the contractor who you will hire, to ensure that you will receive high quality services in your home.

The first thing that you have to check out when you hire contractors to carry out electrical repairs in your home is the amount of experience the employees of the company can boast about. Obviously, you need to find a contractor company that hires mechanics that can carry out the repairs that you need. There are a lot of resources that you may use to find the best mechanics in your area, so you need to make sure that you go through as many of them as possible.

It will do you well to do a run over on the variety of electrical repairs that a certain contractor company offers as well, before you go on to negotiating their working terms. Obviously, you want to find a company that will be able to implement every single repair that you need in your home. Hiring contractors that can boast of a wide range of skills will be best for you, because there will be no doubt that they will know everything that is important in their field. Yes, they will tend to have higher professional fees, but rest assured that you will receive high quality services as well.

Finally, make sure that you hire contractors who will be willing to work within the kind of budget that you have set for the electrical repairs that you need for your home. While it may be a fact that high quality services tend to go for higher rates, this does not mean that you have to shell out an arm and a leg for them as well. Look for a company that will be willing to give you discounts, in exchange for you having all the services that you need carried out by its employees. This way, you will get your house in tip-top shape without breaking the bank.