We all need a little inspiration to reveal our true creativity. If you’ve tired of your boring bedroom’s look, here are five on-trend ideas on how to illuminate your dream bedroom getaway brilliantly.

1. Unexpected objects in the same color family. At first thought, using lamps that are large enough to be placed as floor lamps may seem like it would be cumbersome. But when sleek, unobtrusive and blending in with the surrounding scheme, this can be a fun surprise that draws the eye to details you wish to highlight, such as interesting wallpaper or art.

Take a few minutes to look for and correct electrical hazards in your home. It does not take too long to check the insulation on a table lamp cord, check for the correct wattage light bulbs and install a GFCI (Ground Fault Circuit Interrupter). Take the time. It will prevent an electrical safety hazard and save you and your loved ones lives.

Unsafe conditions such as overloaded circuits and damaged insulation as well as the misuse of extension cords and electrical devices create fire hazards and may result in serious electrical injury.

Studies of residential electrical fires show that the majority of serious fires could have easily been avoided. The conditions that caused the fires probably would have been detected by an electrical inspection. These problems were not detected or corrected because no inspections had been made for several years. In a number of cases homes ranging from 30 to 100 years old had not been inspected since they were built. A safety inspection should be performed by a qualified licensed electrician.

One good tip to determine when your electrical system was last inspected is to examine the door and cover of your electrical panel. The panel should contain a label or tag with a date, a signature, or initials on it. If there is more than one date, the most recent one should be the date of the last inspection. DO NOT remove the service-panel cover. This is a job for a qualified electrician. If the date is older than ten years, its time for a inspection and correction of any problems that show.

Call us for help at 808-647-0599

We’re proud to announce the arrival of new high-CRI architectural retrofit LED downlights. The LED lights are available in a variety of sizes and wattages for applications ranging from retail, commercial, grocery store, hospital, and auditorium lighting to bathroom, basement, and kitchen lighting. Can light replacements have integral junction boxes with round and square knockouts, and architectural downlights are equipped with driver enclosure boxes. These energy-efficient LED lights can be easily wired to code and are IC rated for safe contact with insulation.

Under-Cabinet LED Lighting Kit is available for purchase that contains a plug-and-play LED light strip, push-button dimmer, remote, 12V power supply, and connection accessories. If you want to build a custom kit, follow the steps below the diagram to ensure that you get everything you need.

3. Select a dimmer or controller

For single-color LED strip light setup

Select the power supply large enough to operate the amount of LED strip light you need to use. If you want to control the brightness of your light strips, you will need a Single-color dimmer shown installed with a non-dimmable power supply

For color-changing LED strip light setup

Follow the instructions above for the single-color light strip setup. However, instead of a dimmer, use a RGB color-changing light strip installation

4. Use an LED amplifier for long runs of strip

Depending on the strip chosen and its maximum run (the number of strips that can be installed consecutively before needing amplifiers), you will need to install an light strip interconnect cables. It is best to purchase a length of strip that is more than your application requires. For example, if your project requires 8 1/2 feet of strip, we recommend purchasing 9 feet of strip to ensure that you have everything covered.