How old is your home? Has your electrical system been updated within the last 5 – 10 years? If you haven’t asked these questions recently, it’s probably time to examine your options! Older homes with older electrical systems aren’t typically able to handle the stress of modern electrical appliances. So what can you do to make sure your home can safely run all of your appliances and electronics? Typically, a heavy up can be the answer to your problems. But should you install one? Let the experts at Kolb Electric answer!

A heavy up is an increase in the amperage (power) of your main electrical service. But how can you know if your home is in need of an increase of amperage? There are some things you can check to make sure you’re in need:

Depending on your specific goals, you have a range of upgrades available when thinking about a heavy up. Some service upgrades are as simple as adding a few additional circuit breakers to the existing box, or expanding the box with a subpanel. More complex upgrades may include things like replacing a fuse box or an aging panel with one that allows for higher energy capacity. A Kolb Electrician can evaluate the condition of your current panel with any problems you are experiencing to determine how extensive your upgrades will be.

The time depends on the job. Adding additional breakers to an existing panel is usually pretty quick, often taking less than an hour. Installing a subpanel is not too complicated either, often taking no more than a few hours.

Where it starts to take a long time is when you need to make serious upgrades. If you need to replace a fuse box or circuit main, you could be looking at a job that takes all day.

Regardless of bends, twists, or turns, Example of a cut line on LED strip lights

2. You will now have two LED strip lights. Carefully peel back the end portion of the paper strip covering the strip’s adhesive backing, and then remove the 3M VHB adhesive from the solder pads on the bottom side of one of the strips. The strip with its adhesive peeled back will be the top strip when soldered.

5. Align the non-tinned strip segment (strip with adhesive removed) directly over the newly tinned pads, and apply heat. Hold the soldering iron in place until the solder remelts and begins to flow. To strengthen the bond and improve visual appeal, a small portion of solder can be added to the top pad.

The LED strip lights are now connected, and power should flow through the entire length of the strip.

The following steps demonstrate how to split and solder a run of non-weatherproof two-conductor or connecting wires. Peel away the blue wire so that only the positive (red), negative (black), and control (green) wires are left.

*No wires should be peeled away if you’re joining single-color or standard RGB light strips.

3. Properly heat your soldering iron. For best results, clean and tin the tip of the iron immediately before soldering. To tin the iron, touch solder to both sides of the iron’s tip.

4. Next you will need to tin the solder pads on both ends of the split strip light. When soldering, always apply heat to the target area on the strip and not directly to the solder. Once sufficient heat has been applied to the area, start introducing solder.

The LED strip lights are now connected, and power should flow through the entire length of the strip.

The following steps demonstrate how to split, solder, and reseal a

3. Follow steps two through five located at the top of this post for soldering a standard RGB strip light.

4. To reseal the strip light, apply

The LED strip lights are now connected, and power should flow through the entire length of the weatherproof strip.

With all of the Read more on retrofitting vs replacing here.

Undeniably the best technology for any business is a LED retrofit. Why is this? For many reasons:

What is LED Retrofit and it’s Benefits?

LED Retrofitting is one of the biggest lighting upgrades building are doing these days. Companies want to get rid of technology like LED with retrofit kits can bring along many is an organization that tests lights and either deems them of being quality and efficient or not. If your industrial lights you are inquiring about are not on the DLC or EnergyStar, you should avoid these at all costs.