Under-Cabinet LED Lighting Kit is available for purchase that contains a plug-and-play LED light strip, push-button dimmer, remote, 12V power supply, and connection accessories. If you want to build a custom kit, follow the steps below the diagram to ensure that you get everything you need.

3. Select a dimmer or controller

For single-color LED strip light setup

Select the power supply large enough to operate the amount of LED strip light you need to use. If you want to control the brightness of your light strips, you will need a Single-color dimmer shown installed with a non-dimmable power supply

For color-changing LED strip light setup

Follow the instructions above for the single-color light strip setup. However, instead of a dimmer, use a RGB color-changing light strip installation

4. Use an LED amplifier for long runs of strip

Depending on the strip chosen and its maximum run (the number of strips that can be installed consecutively before needing amplifiers), you will need to install an light strip interconnect cables. It is best to purchase a length of strip that is more than your application requires. For example, if your project requires 8 1/2 feet of strip, we recommend purchasing 9 feet of strip to ensure that you have everything covered.

With all of the Read more on retrofitting vs replacing here.

Undeniably the best technology for any business is a LED retrofit. Why is this? For many reasons:

What is LED Retrofit and it’s Benefits?

LED Retrofitting is one of the biggest lighting upgrades building are doing these days. Companies want to get rid of technology like LED with retrofit kits can bring along many is an organization that tests lights and either deems them of being quality and efficient or not. If your industrial lights you are inquiring about are not on the DLC or EnergyStar, you should avoid these at all costs.

If the motor seems to be fine, attempt to reconnect it to a load. For motors spinning in the wrong direction that are three-phase, swap any two leads either in the starter or in the motor connection box to reverse its rotational direction. Motors that struggle with a load may have something plugged up or jammed in the load itself. A mechanic may be required to check fans, belts, or pumps that are powered by a motor. When a motor trips the overload device, attach an anmeter to measure the current during startup and operation. Check the FLA on the motor nameplate to see what the expected current draw should be. If it is high, the motor may simply be overloaded. If not, the overload protection device may be set too low or may need replacing.

By following these basic ac motor troubleshooting tips, any electrician can quickly determine the cause of most problems in an AC motor.